the control center allows to manage the basic functions of the system. It performs the main commands and allows to perform simple customization cycles. Useful for demos, diagnostics and troubleshooting:
LOAD CARD
picks up a document from the hopper and takes it to the next station. The destination depends on the system title. In desktop systems the target is the laser position, in modular systems the first module after the feeder
FLIP CARD
flip the card on the opposite side in case of card personalization system. This command is not available on passport personalization system
EJECT CARD
The card or passport is ejected into the output bin
RESET TRANSPORT
Reset the document trasport, clean the path and, where available, reject eventual cards inside the unit
LOAD TEMPLATE
Load one of the Jobtemplate available on the application
START RED POINTER
Enable the laser diode to simulate the printing using the red aiming beam
STOP RED POINTER
Switch off the laser diode used as aiming beam
MARK FRONT
If the job template has been loaded the mark front button will start the laser personalization. The button is disabled if no template has been loaded or laser is not enabled (i.e: interlock)
MARK REAR
If the job template has been loaded the mark rear button will start the laser personalization. The button is disabled if no template has been loaded or laser is not enabled (i.e: interlock)